 |
|
Current group: comp.terminals.
Re: wyse 520, reset password
|
|
| | From: | Cute Swinger 8\) | | Subject: | Re: wyse 520, reset password | | Date: | Tue, 21 Dec 2004 20:23:50 -0500 |
|
|
 |
--
Start the New Year off with some adult toys
Or movies!! Best prices around!
FAST & Discrete shipping!
http://www.toy.com/a2k4
-=-=-=-=-=-=-=-=-=--=-=-=-
Looking to Find a Date?? With a REAL PERSON??
http://68.82.94.85:2000/Public/singles.htm
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
Looking to find local swingers & hookups?
Couples? Singles? SEARCH BY ZIPCODE!
100% FREE
http://68.82.94.85:2000/public/swingers/index.htm
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
You can also checkout our NEW all GAY site at
http://68.82.94.85:7000
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
Want free PC software?? Look no further!
100% TOTALLY FREE SOFTWARE
http://68.82.94.85:999/free.htm
"Richard S. Shuford" wrote in
message news:rshu_20030822_154545@stratagy.com...
> Simon Strandgaard wrote:
> ::
> :: I got my hands on an old WY-520 terminal and want to try
> :: it out. Unfortunately the 'setup' menu is password protected.
>
> Wyse documented a complete-reset procedure given for a different
> model terminal. I don't know if it would work, but you could try:
>
> http://www.wyse.com/service/support/kbase/wits/13205.txt
>
> WY99GT "G-Key" RESET INSTRUCTIONS
>
> Please be sure to reset the terminal after installation of firmware chips
as
> follows:
>
> 1. Turn the terminal off, and remove the cabling from the Auxiliary and
> Modem ports.
>
> 2. Hold down the "G" key on the terminal keyboard while booting up. (You
> must keep holding the "G" key down throughout the power up sequence).
>
> 3. Wait for the terminal to finish its screen diagnostic during the power
> up sequence. You can tell when this is over when you see that the
> screen stops flashing. The status line may appear after a few
seconds.
>
> 4. Release the "G" key and go into setup: (Shift-SetUp.) or
(Shift-Select)
> or (F4).
>
> 5. Default all setup parameters by highlighting "DEFAULT ALL":
> (Enter the right arrow key three times) and then the F10 key.
> (Enter F10 again to EXIT or you may change the terminal settings at
> this time.
>
> Occasionally the terminal's personality parameter will "disappear".
> Repeating step 5 several times should correct this.
>
> (The key sequence to get into SETUP will vary depending on the keyboard
type.)
>
> Other information on video terminals is here:
>
> http://www.cs.utk.edu/~shuford/terminal_index.html
>
> ...RSS
>
|
|
|
| | |
|
 |